Hi guest! Maybe consider registering on our new shiny forums!
Disassembly and assembly of water ring vacuum pump
Started by lay1014


Rate this topic
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5


0 posts in this topic
lay1014
Junior Member
**


0
5 posts 5 threads Joined: Oct 2019
12-09-2019, 09:18 AM -
#1
Disassembly and assembly of water ring vacuum pump

1. Before disassembly, drain the water in the pump body, and remove the separator and connecting pipe. The order of pump removal from the rear end (one end without coupling) is as follows:

(1) remove the bearing housing cover, remove the pressure washer, loosen the bearing housing nut and remove the bearing housing.

(2) remove the bearing frame, loosen the gland nut and remove the gland.

(3) loosen the tension bolt and remove the rear end cover after the foundation bolt of the pump cover is loosened.

(4) remove the pump body.

(5) remove the coupling and flat key, loosen and remove the front bearing gland.

(6) take out the pump shaft and impeller together from the front end cover, and loosen the front bearing frame.

2. Assembly

Clean all mating surfaces, apply new oil to the bearing after cleaning, and apply new oil to the bearing seat. The assembly sequence is the reverse of disassembly. At this time, adjust the position of the impeller in the pump body


Oil Free Vacuum Pump In Milk Filling Production Line

2BE1 Series Liquid Ring Vacuum Pump

2BE3 Series Liquid Ring Vacuum Pump


Forum Jump:


Users browsing this thread: